)
Sliding Door Roller Bearing on Door Arm DELRIN
GO WESTY. Vanagon 84-91. Replace your worn-out steel roller bearing on your sliding door with this low-friction solution!
If you have an '84, please check to see if your van has this roller. Earlier models have a plastic bushing in this location.
The outer roller surface is machined from Delrin®, a super tough material for quiet, low-friction operation. The sealed precision ball bearing keeps out dirt and provides a smooth rolling action.
This roller bearing fits the rear "arm" that swings out of the slider track.
Installation Note: You shouldn't need to hammer these bearings on. If the fit over the shaft is snug, take some sandpaper or similar abrasive and clean any corrosion or debris off the shaft before fitting. If any force is needed to seat it, press on the inner race of the bearing, not the outer Delrin® piece.
251843361B
If you have an '84, please check to see if your van has this roller. Earlier models have a plastic bushing in this location.
The outer roller surface is machined from Delrin®, a super tough material for quiet, low-friction operation. The sealed precision ball bearing keeps out dirt and provides a smooth rolling action.
This roller bearing fits the rear "arm" that swings out of the slider track.
Installation Note: You shouldn't need to hammer these bearings on. If the fit over the shaft is snug, take some sandpaper or similar abrasive and clean any corrosion or debris off the shaft before fitting. If any force is needed to seat it, press on the inner race of the bearing, not the outer Delrin® piece.
251843361B
Part #: GVW-251-843-361B
USD 26.27