13mm Curved Wrench

Handy for working on carbs on air-cooled vehicles, and also on diesel injection pumps on water-cooled cars.

19mm Hex Bit Socket

1/2" drive 19mm hex bit socket.

Axle Nut Tool - 36mm

Remove rear axle nuts with this tool
For T1/T3/T4
Up to 62 Bus

Axle Nut Tool - 46mm

Bench Mount Head Assembly Tool

Bench Mounted Engine Stand.

EMPI. Features swivel head. Use for holding engines or transmissions. 1-5/8" male tube that slides into the mount. Fits all air-cooled VW motors and 3...

Carb Sync Adapter - 34 ICT/EPC

Adapter shown in RED in the pic. Carb and sync not included.

Carb Sync Adapter - Kadron

Solex/Brosol "kadrons". Adapter shown in RED in the pic. Carb and sync not included.

Carb Sync Tool Bubble Style

EMPI.

Carb Sync Tool Univ. Pro-Sync

EMPI. Includes 2 adapters.

Case Splitter Tool

EMPI. Insert in the oil pump hole and expand the case halves.

Clutch Align Tool T1/T250-71

Fits : Bus 1950-1971. Beetle 49-79.

Clutch Align Tool T2 72-92

Fits : Bus 1972-1979, Van 1980-92 except diesel.

Clutch Cable Adjusting Wrench

Crank Gear Puller 1200-1600cc

EMPI. For 1200-1600cc motors.

Crank Pulley Pulling Aid Tool

Crankshaft Measuring T1 #1-3

CSP. Crankshaft measuring tool. Simple devise to find the correct crankshaft bearings for any Type-1 crankshaft. Bearings 1-3.

Crankshaft Measuring T1 #4

CSP. Crankshaft measuring tool. Simple devise to find the correct crankshaft bearings for any Type-1 crankshaft. Bearing 4.

CSP Pushrod Tube Install Tool

CUSTOM SPEED PARTS. Installation tool for CSP push rod tubes.

Deck Height Measuring Tool

EMPI. Beetle 1200-1600cc style motors.

Distributor Drive Puller Tool

For removing distributor drive from air cooled motors.

End Play Measuring Tool

For measuring end play on VW air cooled motors.

Engine Case Measuring T1 #1-3

CSP. Engine case measuring tool. Simple devise to find the correct crankshaft bearings for any Type-1 engine case, main bearings #1-3.

Engine Case Measuring T1 T4 #4

CSP. Engine case measuring tool. Simple devise to find the correct crankshaft bearings for any Type-1 engine case or T4 engine case , main bearing #4.