Engine Case Measuring T1 T4 #4
CSP. Engine case measuring tool. Simple devise to find the correct crankshaft bearings for any Type-1 engine case or T4 engine case , main bearing #4....
CSP. Engine case measuring tool. Simple devise to find the correct crankshaft bearings for any Type-1 engine case or T4 engine case , main bearing #4....
CSP. Engine case measuring tool. Simple devise to find the correct crankshaft bearings for any Type-4 cylinder 1-3. German.
EMPI. For the Pro Engine Builder. Features 2 long, diagonal forward legs for stability and strength, Urethane-clad wheels each with brake and a 4-arm,...
EMPI. Flywheel Seal Tool. Deluxe Version. For beetle upright style motors. For installing rear main seal on air-cooled VW motors.
EMPI. Flywheel Seal Tool. Econo Version. For beetle upright style motors. For installing rear main seal on air-cooled VW motors. 5775
GOWESTY. This flywheel seal installation tool is an affordable version of the Volkswagen tool VW191 with a very important added feature: it doubles as...
EMPI. Combustion Camber C.C. Measuring Kit. Includes disc for 85.5, 90.5, 92/94 Cylinders. 16-9603
TMI. For installing upholstery onto seat frames. Very handy tool !
EMPI. Hub cap removal too. Pull off those pesky hub caps ! 98-0113-B / 251012243
Hub cap removal too. Pull off those pesky hub caps ! 98-0113-B / 251012243
EMPI. Pair. Hubcap removal tool and jack point cover. Stainless steel cover on plastic body and plated wire. This is a reproduction of the original ac...
Install your new hubcap clips the proper way with this handy tool. Simply clamp the mandrel into a standard bench vice, and peen rivets with a hammer ...
EMPI. This Jack Plate slides into the stock jack support, on all Volkswagens with this
designated input below each door. It allows for a safe and conv...
For removing or tightening the nut holding on the oil filler of Beetle style engines. Use with 1/2 inch drive extension.
For pulling oil pumps from the case of 1200cc-1600cc air cooled beetle engines. Does not work on full flow pumps.
For pulling oil pumps from the case of 1200cc-1600cc air cooled engines. Does not work on full flow pumps.
Pinion nut tool for 6V T1 trans and early swing axle.
Nut itself not included.
Pinion nut tool, late. Fits Late T1, 002, 091, 094 and Syncro front diff.
For nut with 15 "teeth"
Can be used with C-1TL-PIN-Hold, or other holdin...
Pinion nut tool. For the early style of pinion nut with 16 "teeth".
See images for style of nut.
Used in conjunction with C-1TL-PIN-HOLD tool, or ...
Pages: |